|home > ||Tom < Ambler > Loki||7 September 2017|
|Ambler by David Buckley
Pop July 2002|
Mom August 2002
Joe November 2002
Kas November 2003
Jet December 2009-
After Tom I decided for the Ambler biped robots to revert back to two servos and the size of BigFoot and Toddler but still kept the tilt rods at the rear. This was a very successful design. The first Ambler Pop, aka Sam, with the batteries on the feet now walked much better and faster than Toddler. I decided to build a slightly different version Mom, aka Efi, with the batteries on the body. The walking action is different because of the increased mass high up and the reduced mass of the feet but Mom is just as good a walker as Pop. After building Junior these just had to be Mom and Pop especially as they are smaller.
Although at slow speed the Amblers walk using predefined gaits, at fast speed, the frame and tilt rods, because they are flexible, store and release energy throughout the walking cycle, consequently the Amblers are Active Dynamic Biped Walkers with Limit Cycle Control.
BigFoot Toddler Junior Tom Sam(Pop) Efi(Mom)
Following on from BigFoot, Ambler, designed by David Buckley, is the latest generation of two servo biped walkers. The kit is aimed specifically at the beginner in electronics and robotics and comes with the control-board already assembled. No special knowledge of electronics is required and the kit is easy to assemble using a small screwdriver, a pair of pliers and wood-glue.
Ambler uses two servos to achieve real walking, rolling from one foot to the other as it walks forwards, backwards and turns right or left all under the control of a Basic Stamp2 from Parallax Inc. or with any other compatible module.
Ambler stands about 24 centimetres high and weighs 560 grams (9.5" high, weighs 20oz), has an onboard Sounder, UserPot and large Breadboard area.
Requires four AA cells and a PP3 9v battery.
The two servos allow Ambler to shift its weight from one foot to the other and thus lift either foot and to move its legs forwards and backwards. Turning is done by standing upright and sliding the feet in a tank style turn. A simple fully documented Basic program is provided. The supplied program operates Ambler in a static balance walking mode.
The two toe switches, one on the front of each foot, are activated when the wires seen in the photo touch obstacles. Ambler can then be made to step back and turn away.
Ambler is available from Milford Instruments.
A full build manual is available for download from Milford's site, see >robots>Ambler